Men Die When Bridge Equipment Collapses
The men must have felt privileged to work on the largest public works project in the state?s history, the building of an interstate highway bridge, but for several, their excitement turned to tragedy.
The men must have felt privileged to work on the largest public works project in the state?s history, the building of an interstate highway bridge, but for several, their excitement turned to tragedy.
A man was strangled after his shirt-sleeve was caught by the rotating drill bit of a drill press he was operating.
The former manager of Atlantic States Cast Iron Pipe Co. [...]
A mixer operator in a cement roofing tile plant noticed that the sand was not flowing from the bottom of a hopper onto the conveyor belt. A plant laborer was instructed by the operator to
A man working in a steel plant was removing steel slag from the bottom of an upright ladle. He was using a jack hammer, a pry bar and a cutting torch fueled by acetylene and oxygen.
A clean-up worker was killed when struck by a rotating cut-off saw as he and a co-worker tried to clear a logjam on a mill conveyor. The victim, a temporary employee who had worked at
A laborer was steam cleaning a scraper used in a street paving project. The hydraulically-controlled bowl apron of the scraper weighing approximately 2,500 pounds had been left in the raised position. It had not been
A faller started his chainsaw and heard a squealing noise from it. He turned the saw over to see if it was catching on anything. It did not appear to be. He then turned the
Hospital workers are certainly not unaccustomed to death, but when a fellow worker dies in an incident there, shock waves reverberate throughout the facility.
An unsafe practice that was allegedly encouraged by his employer resulted in a 52-year-old man losing his life in December 2005.
A service worker for a security alarm system company died after a 35 foot (10.6 meter) fall.
A 45-year-old farmer was working with two neighbors who had come to help him load corn into a wagon to feed cattle.
A 56-year-old construction worker died after he was run over by a bulldozer. He was acting as a spotter to help a truck driver move his vehicle.
A 32-year-old laborer for a boring and tunneling company died when he was struck with a hydraulic hose.
Had the crew of a barge used a steel pin [...]
Three employees equipped with respirators were preparing to paint a heat exchanger in a manufacturing plant. Their sandblasting work was almost finished. The portable air compressor used to supply breathing air to the sandblasters' hoods
A worker died of injuries received in an explosion when hot material from a cutting torch ignited a can of solvent. The incident occurred in a metal products plant which was temporarily out of operation.

A cleanup person was instructed by his foreman to do the cleanup of a conveyor area jammed with debris. This involved loading the debris onto the conveyor, running it until it was clean, shutting it
Workers tending a paper manufacturing machine had to enter an narrow overhead platform above a moving press roller. One day a worker was on this 14-inch (.35-meter) wide platform structure. He was using a compressed
A worker was using a chainsaw to trim the ends off spacers used to separate layers of lumber in preparation for drying in a kiln. He was working alone although other workers were close by.
The following is a real-life example of what went wrong and what corrective measures resulted from a fatal incident in the oil and gas industry.
Two feet of water would not seem to pose a drowning hazard for an adult, but it proved fatal for a 25-year-old lawn maintenance worker in New York. The 25-year-old man died after his riding mower tipped over into a pond in an industrial park.
A 19-year-old worker died when he reached inside the hopper of a rear-loading trash truck while it was cycling trash.
A 27-year-old farmer was pulling a picking machine through a cornfield with a tractor.
One laborer was electrocuted and two others were injured when a boom crane with an attached auger accidentally came into contact with a 7,200-volt overhead power line running above a materials storage yard.