Main Category Group
High Voltage and Arc Flash
Talking to your workers about electrical hazards is always timely. [...]
Main Category Group
Talking to your workers about electrical hazards is always timely. [...]

At approximately midnight, a worker was attempting to repair a leak in a hydraulic cylinder of a newly installed washer in a commercial laundry plant. Leaning under the machine, he attempted to unhook a hydraulic
A defective brake caliper exploded during a test while it was being repaired in a shop. One worker was killed and two more were injured by the flying fragments. The brake caliper had been part
The driver of a flat deck truck loaded with bricks was killed when the vehicle hit a soft shoulder, went out of control, crossed into oncoming traffic and collided head-on with a tractor-trailer. The incident
A worker in a steel mill was removing steel slag from the bottom of a ladle, about 14 by 10 by 8 feet in size. He was using a jackhammer, a pry bar and an
Lack of oxygen killed a farmer who fell into a silo. He was preparing for the arrival of corn to be placed in the top of the silo. He climbed into the top of the
A company was contracted to dig post holes for a fencing project which was located adjacent to overhead power lines. A hydraulic auger with a 30-foot boom was being operated from a flatbed truck. On

Early in the evening an operator of a crane was installing storm sewer pipes. Suddenly, the boom of the crane contacted the overhead high tension wires. A pipe layer who was guiding the pipe as
An aerial lift truck was parked on a hill beside a power line. Its driver set the emergency brake, but did not chock the wheels or engage the outriggers on the lift truck. The utility
A painter fell 25 feet (7.62 meters) from the top of a tank to the concrete pad below. He died of multiple traumatic injuries.
A worker died in a flash fire which occurred when a static spark ignited solvent vapors on top of a large blending tank in a manufacturing plant. The spark, which was either from his clothing
An explosion in a fuel tanker killed a worker loading the truck. The cause of the explosion was a static spark generated by the pumping of a thick oil product into the tanker. The spark
A shortcut across a moving conveyor belt was a fatal decision for a worker. He was watching the conveyor when he noticed a piece of timber fall to the floor instead of into the waste
The boom of a log loader dropped suddenly and killed a logging truck driver as he was helping load a pulp truck. He had climbed up an access ladder to the loader cab to hand

A cleanup person was instructed by his foreman to do the cleanup of a conveyor area jammed with debris. This involved loading the debris onto the conveyor, running it until it was clean, shutting it
A shift supervisor in a paper mill bled to death after both his arms were caught between two paper machine rollers. He entered an unguarded metal walkway that provides access to the area without first
A reel handler fell into a water pit and drowned while attempting to repair a machine used in manufacturing paper. He was trying to patch the bottom of a wire mesh screen belt. The apparatus,
A lumber inspector was crushed to death by a two ton stack of lumber which fell on him. The incident occurred in the yard of a lumber retailer. The inspector was crouching in front of
About a half hour before the end of his shift, a warehouse worker was walking along a general usage aisle. The worker apparently didn't notice that a working forklift was also there. The forklift driver
A watchman at a manufacturing facility was suffocated when a 30-foot pile of sawdust collapsed on him. The sawdust was being used to fuel a wood-fired boiler furnace.
A worker was using a chainsaw to trim the ends off spacers used to separate layers of lumber in preparation for drying in a kiln. He was working alone although other workers were close by.
Two workers rode a self-propelled lift machine to their deaths as it crashed to the ground. One was washing windows and the other was obtaining measurements for building changes. One of the victims was operating
A relatively new truck driver was engaged in transporting rock from the underground blasting area in a mine to the surface. He was still in what has been referred to as a "training position." He
A volunteer firefighter was fatally injured after being thrown from a water tanker during a rollover. The victim was traveling to a wildland fire on an unpaved road within a national forest. The tanker went
Tell your crew about what happened to these workers. Failing to identify hazards before a job leads to many accidents in the oil and gas industry.