Main Category Group
Argon gas used as part of a welding operation caused the asphyxiation death of an apprentice welder working in a confined space. He was completing welding work inside a tank being constructed of titanium. Because
An explosion at a metal recovery plant killed one worker and endangered the lives of other plant employees as well as those working in the surrounding area. The victim, a 20-year-old who had worked in
A journeyman electrician was found dead in an office building crawl space after he had changed a ballast. He was new to the job site but had been given a familiarization tour a few days
Late in the afternoon, a worker at a manufacturing company was requested to clean out a vat. It was approximately 5 feet deep and 5 feet in diameter. He was instructed to use
When a construction foreman was found dead in water at the bottom of a manhole, his workers followed him into the confined space and risked death themselves. The fatality occurred when his crew was installing
A worker died of electrocution when a cable hanging from a crane touched a high voltage power line. He was helping to unload concrete pilings from a flatbed truck, and was guiding the pilings as
A cable television installer was working from an aerial lift bucket as he strung wires for television cable. He was using a saw to cut tree branches which were in the way. As he elevated
A plant worker climbed eight feet up a steel storage rack structure to retrieve material from a top shelf. He fell to the concrete floor and died. The workplace did not have the proper equipment
A 17-year-old lifeguard preparing for summer was found dead in just inches of water after she fell 14 feet (four meters) into a nearly empty pool. The tragedy occurred while a crew of four were
A storage tank with approximately 200 gallons of combustible ink was accidentally damaged while it was being moved, causing a leak. A considerable amount of liquid had spilled onto the floor before it was noticed.
Two finishers were working with a chemical product on a parquet tile floor in a residential basement. The heavier-than-air vapors from the product accumulated and spread to an adjacent room where a gas-fired water heater
An operator of an excavator struck a water line while digging a trench, causing water to spray around. A worker in the trench took his shovel and started tossing water back at the excavator operator.
Two workers were assigned to unload a barge tied up at a riverside dock. One was operating a front end loader to transfer lime into a portable conveyor to carry it up to the dock.
A machinist was finishing a piece of stainless steel on a lathe. The metal shavings peeled off the rotating lathe in one large wire strand and wrapped around his neck, causing partial decapitation. Investigation of
Co-workers saw an 18-year-old laborer being pulled between the rotating paddles of a portable mortar mixer. The young worker was working at a residential construction site, cleaning the mixer for the next day’s work, when
Most victims of heavy machinery collisions are workers, but occasionally passersby are also struck by equipment. For example, a street sweeper moving at about two miles an hour (three kilometers an hour) knocked down an
A worker drove a front-end loader up a dirt ramp onto a lowboy trailer in preparation for a move to another job site. As the loader reached the trailer, the tractor tread began to slide
About mid-day a foreman and three carpenters were assisting a crane operator with the placement of a 6000 pound steel mat. The mat was constructed of approximately 80 pieces of reinforcing steel each weighing about
A worker had been sandblasting equipment in preparation for repairs. A co-worker later found him dead on the floor. The victim had been using a supplied-air respirator, but it appeared he had mistakenly plugged it
A laborer working in a pulp mill went into an old, unused control room for his lunch break. Warning lights were flashing indicating a potentially dangerous situation with a plugged pressure sensing device. The worker;
A worker received massive head injuries when a crane lifting a 54,600-pound piece of steel tipped over. The crane was unstable because one outrigger device, which extends from the crane to balance it was inoperable.
A visitor to a hospital was seriously injured when he was hit by a motor vehicle carrying laundry. The driver was backing up and did not see him. The victim died three days later during
A container of volatile flammable liquid fell to the floor in front of an electric heater. The vapors reached the hot element and started a flash fire and explosion.
Electrical lines were grounded and de-energized before a lineman went to work on them, but he still died of electrocution. He was working from an aerial lift with an articulated boom. The basket touched energized
A maintenance worker with no electrical training was electrocuted while doing renovation work in a 10-story office tower. The victim was standing on an aluminum ladder removing ceiling tiles when both hands made contact with
Since it's your first time, you may want to checkout some of the video tutorials.
800-ICW-SAFETY (800.429.7233)
SAFETYOnDemand@icwgroup.com