Main Category Group
Corrections Officer Dies Six Months After Fall
A 40-year-old corrections officer died of injuries received when he [...]
Main Category Group
A 40-year-old corrections officer died of injuries received when he [...]
Argon gas used as part of a welding operation caused the asphyxiation death of an apprentice welder working in a confined space. He was completing welding work inside a tank being constructed of titanium. Because
An explosion at a metal recovery plant killed one worker and endangered the lives of other plant employees as well as those working in the surrounding area. The victim, a 20-year-old who had worked in
A journeyman electrician was found dead in an office building crawl space after he had changed a ballast. He was new to the job site but had been given a familiarization tour a few days
Late in the afternoon, a worker at a manufacturing company was requested to clean out a vat. It was approximately 5 feet deep and 5 feet in diameter. He was instructed to use
When a construction foreman was found dead in water at the bottom of a manhole, his workers followed him into the confined space and risked death themselves. The fatality occurred when his crew was installing
A worker died of electrocution when a cable hanging from a crane touched a high voltage power line. He was helping to unload concrete pilings from a flatbed truck, and was guiding the pilings as
A cable television installer was working from an aerial lift bucket as he strung wires for television cable. He was using a saw to cut tree branches which were in the way. As he elevated

A plant worker climbed eight feet up a steel storage rack structure to retrieve material from a top shelf. He fell to the concrete floor and died. The workplace did not have the proper equipment

A 17-year-old lifeguard preparing for summer was found dead in just inches of water after she fell 14 feet (four meters) into a nearly empty pool. The tragedy occurred while a crew of four were

A storage tank with approximately 200 gallons of combustible ink was accidentally damaged while it was being moved, causing a leak. A considerable amount of liquid had spilled onto the floor before it was noticed.
Two finishers were working with a chemical product on a parquet tile floor in a residential basement. The heavier-than-air vapors from the product accumulated and spread to an adjacent room where a gas-fired water heater
An operator of an excavator struck a water line while digging a trench, causing water to spray around. A worker in the trench took his shovel and started tossing water back at the excavator operator.
Two workers were assigned to unload a barge tied up at a riverside dock. One was operating a front end loader to transfer lime into a portable conveyor to carry it up to the dock.
A machinist was finishing a piece of stainless steel on a lathe. The metal shavings peeled off the rotating lathe in one large wire strand and wrapped around his neck, causing partial decapitation. Investigation of
Co-workers saw an 18-year-old laborer being pulled between the rotating paddles of a portable mortar mixer. The young worker was working at a residential construction site, cleaning the mixer for the next day’s work, when
Most victims of heavy machinery collisions are workers, but occasionally passersby are also struck by equipment. For example, a street sweeper moving at about two miles an hour (three kilometers an hour) knocked down an
A worker drove a front-end loader up a dirt ramp onto a lowboy trailer in preparation for a move to another job site. As the loader reached the trailer, the tractor tread began to slide
About mid-day a foreman and three carpenters were assisting a crane operator with the placement of a 6000 pound steel mat. The mat was constructed of approximately 80 pieces of reinforcing steel each weighing about
A worker had been sandblasting equipment in preparation for repairs. A co-worker later found him dead on the floor. The victim had been using a supplied-air respirator, but it appeared he had mistakenly plugged it

A laborer working in a pulp mill went into an old, unused control room for his lunch break. Warning lights were flashing indicating a potentially dangerous situation with a plugged pressure sensing device. The worker;

A worker received massive head injuries when a crane lifting a 54,600-pound piece of steel tipped over. The crane was unstable because one outrigger device, which extends from the crane to balance it was inoperable.
A visitor to a hospital was seriously injured when he was hit by a motor vehicle carrying laundry. The driver was backing up and did not see him. The victim died three days later during
A container of volatile flammable liquid fell to the floor in front of an electric heater. The vapors reached the hot element and started a flash fire and explosion.
Electrical lines were grounded and de-energized before a lineman went to work on them, but he still died of electrocution. He was working from an aerial lift with an articulated boom. The basket touched energized