Maintenance Person Dies After Getting Head Stuck
Alcohol use may have been a major factor in the suffocation of a general maintenance worker repairing a water leak.

Alcohol use may have been a major factor in the suffocation of a general maintenance worker repairing a water leak.

At 21, Catrina Faye Coffman had everything to look forward to.

A fall from 25 feet (7.5 meters) killed a construction worker.

A barge maintenance worker was found dead of asphyxiation in a compartment on the vessel. The barge, used as a construction base camp, was being prepared for the upcoming construction season. On the day of

An experienced worker and his untrained helper lowered an aluminum ladder into an underground fuel storage tank. A small access hatch had been cut into the tank using a water cooled saw. One of the

A 17-year old worker died just one hour into his new job after becoming pinned under a forklift. He hadn't received any job orientation or training.

Safety training is critical for any job and if you don't provide it and a worker becomes injured or dies as a result, you and your company could face a legal nightmare.

A journeyman painter died of massive thermal burns caused when an electrical contact set off an explosion of volatile waterproofing material. The painter and a co-worker were in the basket of a personlift, designed to

A foreman placed a wooden ladder into a mixing vat that had recently been sprayed with a cleanser called methylene chloride. While on the ladder, he called over to a co-worker to start the fan in the vat.

The murder of a teenage girl on her first solo night shift at a gas station has brought calls for improving security for night workers who must work alone.

You may be considered a veteran in your workplace, but veterans are not invincible.

While helping to reshingle a farmhouse roof, a worker was handling an aluminum ladder. The ladder contacted 7,200 volts of electricity when it hit a power line. The worker was electrocuted. An electrical entry wound

Three workers, one licensed electrician and two apprentices, were rewiring a residential basement. They were using a 300 watt lightbulb, drawing power from a temporary connection to power wires on an outside pole. The electrician

A 23-year-old mill worker received a compound fracture to his foot when he tried to clear a conveyor jam.

A fire that killed a Long Island, NY, man and critically injured his wife was caused by a faulty power cord, according to fire officials.

A flash fire killed an electrician's apprentice when he touched a switch he thought was de-energized. The mishap occurred at a transformer station. The apprentice was part of a team doing modifications on equipment at

A ladder touching a high tension wire - this scenario has caused countless fatalities in all kinds of industries and workplaces and homes. An employee of an aluminum siding company was electrocuted when the ladder

A maintenance worker died after being drawn into a 172-inch diameter vacuum pipe at a paper processing plant.

Jeffrey Mills was the kind of man who didn't mind going out of his way to help out.

A plant worker climbed eight feet up a steel storage rack structure to retrieve material from a top shelf. He fell to the concrete floor and died. The workplace did not have the proper equipment

A machine at a steel foundry was found to be jammed in the "up" position and could not be lowered. The plant maintenance mechanic, who was an experienced and careful worker, was called to repair
Every single day about 1,000 people injure an eye on the job. Some of these injuries are called "minor", but even a minor eye injury results in lost work time, pain, and sometimes lasting damage.

The victim, a 22-year-old male firefighter recruit collapsed while running at the end of a training day.

After doing the same job for nearly 20 years, a worker died in a falling from the top of a load on a flatbed trailer. He worked for a company which packaged sand, gravel and

A cleanup person was instructed by his foreman to do the cleanup of a conveyor area jammed with debris. This involved loading the debris onto the conveyor, running it until it was clean, shutting it