Steel Load Falls Off Crane
An overhead crane operator died when a bale of steel slipped off the C-hook and hit him. He had positioned the bale incorrectly on the C-hook, so it was not balanced and centered. Ordinarily he

An overhead crane operator died when a bale of steel slipped off the C-hook and hit him. He had positioned the bale incorrectly on the C-hook, so it was not balanced and centered. Ordinarily he
A superintendent on a high-rise construction complex fell to his death after sustaining multiple injuries. Earlier that day, this superintendent was discovered traveling without authorization in a newly installed elevator. As a result, the company

At approximately midnight, a worker was attempting to repair a leak in a hydraulic cylinder of a newly installed washer in a commercial laundry plant. Leaning under the machine, he attempted to unhook a hydraulic
A farmer was crushed by his own tractor when another person was attempting to operate it. The victim was adjusting the spreader which was being towed behind the tractor. Another person tried to put the
Argon gas used as part of a welding operation caused the asphyxiation death of an apprentice welder working in a confined space. He was completing welding work inside a tank being constructed of titanium. Because

A textile worker was working on a conveyor belt. At the end of a day's production she had to clean the belt using a highly volatile cleaning solvent. This solvent was used very close to

A hospital maintenance worker was repairing a broken hand held hair dryer. He asked a co-worker to assist in locating some acetone to remove epoxy from his hands.
A worker was attempting to remove an end plug from a pipe containing a 100 per cent concentration of anhydrous hydrofluoric acid under pressure. He applied sufficient pressure with a wrench to break the pipe,

An experienced crane operator was running an electrically powered gantry crane in a process building which was in the final stages of construction. Other than the occasional use of a propane-powered forklift, there were no
An industrial water meter reader was reported missing when he failed to return to headquarters at the end of his shift. Meanwhile, a passerby saw him lying face-down in a few inches of water at
A manager in a paper plant was draining a tank filled with wood pulp treated with chlorine dioxide, a corrosive material. During the process, some of the chlorine dioxide spilled. He tripped and fell into

A 35-year-old man was found several hours after he died inside a barn he had been cleaning. He had been using a pressure washer with an 11-horsepower gasoline engine.
Workers were preparing to fill a rail tanker car with canola oil for shipment. A hose fell into the car, and one worker climbed into the tanker to retrieve it. He was overcome by the
At the age of 51 a sheet metal worker died of lung cancer. His case was typical of asbestos exposure. He had been exposed during his working career when removing and installing duct work in
A chemical manufacturing worker was splashed with a solution containing 51 percent 2,4-DCP. while moving a hose used to transfer the material. The solution covered 60 to 65 percent of his body surface area including
A worker and his supervisor were working in a confined space using a flammable substance and an acetylene torch. The confined space was a freshwater pumping station. The two men were installing rigid foam insulation
Argon gas accumulated in the bottom of a large tank killed two workers assigned to clean the tank. The atmosphere in the tank had been tested before they entered it, but the testing was done
A worker was thrown 130 feet into the air and fell through the roof of another building when a cutting torch ignited gasoline vapors. The worker had been dismantling a 5000-gallon gasoline tank. He had
A defective brake caliper exploded during a test while it was being repaired in a shop. One worker was killed and two more were injured by the flying fragments. The brake caliper had been part
A miner was killed and a co-worker received serious lung damage when a blasting operation released deadly sulfur dioxide (SO2). The workers prepared the explosives and then set off the blast from a refuge station.
An explosion at a metal recovery plant killed one worker and endangered the lives of other plant employees as well as those working in the surrounding area. The victim, a 20-year-old who had worked in
A laboratory used for analyzing rock samples in the oil and gas industry was the scene of a fatal chemical exposure.
An employee in a manufacturing plant was found dead of a heart attack believed to have been caused by electric shock. This is the chain of events leading up to his death: About two weeks

About two weeks before this fatality, an electrical plug on a power cable of a welding machine was found to be damaged. The broken piece was the protective aluminum cover which housed the plug attached
A laborer in a metal-casting plant was killed when he fell into a vat of scalding hot water. He received burns to 90 per cent of his body. He had been walking on an insulated